bending best
英 [ˈbendɪŋ best]
美 [ˈbendɪŋ best]
【机】弯曲试验
双语例句
- The experiment indicates that the bending strength of 28 days of cement can be increased by 28.6% under the best allocation.
实验表明，在最佳搭配下，可提高水泥的28天抗折强度达26.8%。 - Conclusion The biomechanical experiments of three point bending and tor-sive tests proved that the triangular needle had good elasticity, best restorable function and strongest anti-rota-tion force.
结论通过三点弯曲和扭转生物力学实验证明，三棱针弹性好，可复性能最佳，抗扭转作用力最强。 - The position relationship between beam axis and shaft axis was discussed in lapping with bending disk. The equation denoting the best distance of beam axis and shaft axis was set up, and the error was analyzed.
本文讨论了磨具弯曲成形法中梁轴线与转轴中心线位置之间的关系，给出确定梁轴线与转轴之间最佳距离的计算公式及误差分析。 - Conclusions The method of fetal head delivery with uterus "U" incision using bending elbow upward during emergency cesarean section in the second stage of labour was the best.
结论第二产程急诊剖宫产子宫下段U形切口采用屈肘上托力娩头为最佳娩头方法。 - Detection through the shear, tensile, impact, bending, water resistance, high temperature testing, storage stability to find the best curing agent and its ratio.
检测通过剪切、拉伸、冲击、弯曲、耐水性、高温试验、储存稳定性找出最好的固化剂和配比。 - And their cured and carbon fiber laminate under tensile and bending test, but also tested the best carbon fiber laminates heat resistance.
并对它们的固化物和碳纤维层合板进行了拉伸和弯曲测试，而且还测试了最好的碳纤维层合板的耐热性能。 - The result of anti bending and anti tensile strength test of samples showed: Nb ( 6%) silicated graphite property is the best of all, with its tensile strength increasing 20%-27%;
对这些样品抗折、抗拉强度测试结果表明：Nb（6%）-硅化石墨性能最优，抗拉强度提高了20%～27%； - When bending deformation amount is 9.4% the recoverable strain is best ( 4.0%).
弯曲变形9.4%时，合金的可恢复应变最大（4.0%）。 - The leakage current through DC-AC etched aluminum foil when anode finishing is least, while the tensile strength and bending property of hard AC-etched aluminum foil are best.
直-交流腐蚀箔的漏电流最小，硬质交流腐蚀箔的抗拉强度及折弯次数最大。 - The results show that the impact fatigue life and bending fatigue life increase with the increase of amount of ferrite. The best amount of ferrite is about 10%.
结果表明，铁素体含量增加，冲击疲劳寿命及弯曲疲劳寿命均增长，铁素体含量达到约10%时，这两种疲劳性能为最佳。